OCTOBER 2, 2004
The attach angle for the flap actuator.
The lower attach points for the flap actuator housing.
The actuator mounting bolt through the housing.
The center bearing block, drilled and cut in half.
Another bracket that you have to fabricate. This is the rear housing lower mount.
One of two flap push rods that you have to drill and tap.
Just for grins I mounted the front ribs and skins, looks pretty cool!
This is a screw up on my part, I drilled for the safety wire and got into the inside of the actuator. I will check with Van's and see if I can just epoxy the hole closed and drill another.
The actuator inside the housing. Also note the platenuts. You never get away from installing platenuts on this kit.