NOVEMBER 11, 2007
This is looking from the left side of the engine. The side and rear baffle pieces are fitted but not trimmed for height yet.
To build the front baffle pieces the lower cowl needs to be on. The spinner is first set in position so that the top cowl can be fitted after that the bottom cowl can be fitted;
The rear of the baffle
The right side
Fitting the top cowl. It is shipped too long and needs to be trimmed
The trim line
The required gap behind the spinner
Drilled and clecoed
The lower cowl trimmed, drilled and clecoed in place
Starting to look like an airplane.