NOVEMBER 24, 2006
I had a friend weld the handles to the "roll bar". These are to help us old guys get in and out easier.
More sound proofing. I have only the center section yet to do. I am out of the high temp glue and AC Spruce did not ship until today so I will have to wait until next weekend to finish.
I wired the voltage regulator and starter and master contactor today.
These two shots show the left out board mount that is for the panel in front of the spar. These mounts had to be pop riveted because there is
no way to get to the back side of the rivets.
e 
This is the right side with the panel clecoed on
This is firesleeve that covers the stainless pass through. You can see the pass through in the fourth shot from the top on this page.