FEBRUARY 15, 2004
Today we installed the inboard and outboard ribs. This is the outboard. We also finished the capacitive fuel setup.
The six rivets that hold the reinforcement plate on the outboard rib.
The inboard rib. You can see the three mounts for the fuel plates through the inspection hole. The AN fittings are for the vent (on the left) and the return (on the right). The fuel pick up is not installed yet and will exit the tank at the leading edge. You can also see the B&C connecter above the vent exit.
In addition to the cleco's all this stuff needed to be cleaned after today's work. The amount of clean-up just keeps getting larger and larger.