DEVEMBER 17, 2006
These are the wires for the active traffic system. This is a massive bundle with close to 50 wires.
This is the end of the harness that connects to the power source and all the other equipment that the traffic system interacts with
Same harness at the traffic system box end. The box requires a shelf that I will build in a few weeks.
This piece of coax cable is for the capacitive fuel sender to connect with the AFS2500
Here you can see where the coax enters and passes through the bulkhead and then goes up the vent line.
This is most of the wire that comes from behind the main spar, most but not all.
Same wires, only this end is not hooked to anything yet.
This is why I had to say most of the wire from behind the spar. All of this also goes forward after the wings are installed.
This is the strobe, position light and vor antenna wires for the left wing
More pictures of the handles that I had a friend on mine weld to the roll bar. Thanks Greg
My neighbor, Judy, asked for more shots from outside the plane, so here they are
