AUGUST 13, 2006
This is the stock position for the throttle according to Van's. I am going to cover this with stainless steele and place the throttle as shown in the next shot.
These are the throttle and mixture cables. This will work easier than the suggested placement.
These are the suggested placement for the mixture and prop governor. I will use these for the ram air and purge valve cables.
This is the amp sensor (green) and the voltage regulator (above and to the left)
This is a stainless wire pass through for the engine gauges. I will need at least one more for the ignition wires and vacuumed lines.
It is getting a little tight , but, everything will fit.
The hole with the six smaller holes around it is for the eyeball pass through for the prop governor cable.